Saxperience - Citroen Saxo Forum - View Single Post - Turbo setup, Can standard ecu be mapped for turbo??

tangoedvtsturbo · 1st October 2009, 13:32

i have a vts turbo conversion done by the turbo doc!
rover turbo inlet
TD04 turbo
evo 9 intercooler
external wastegate n screamer pipe
14psi
8000rpm rev limit
megasquirt ecu
just pushed 200bhp at the fly after a kwik remap on the way down to L.A.D in morecambe!
is getting turned upto 18psi n mapped as soon as L.A.D have a free afternoon for me to use the dyno!
THE ENGINE HAD DONE 105000 MILES WHEN THE CONVERSION WAS DONE! NO FANCY PISTONS OR MODS! IT GOES LIKE FOOK N IT WORKS! NO SHINY BITS BUT AT THE END OF THE DAY ITS COST £800 U CANT BUY THIS TYPE OF POWER FOR THE MONEY ANYWERE ELSE!

1st October 2009, 13:32	#86
tangoedvtsturbo Newbie Join Date: Oct 2009 Location: FLEETWOOD` Posts: 16 Car(s): SAXO VTS TURBO	i have a vts turbo conversion done by the turbo doc! rover turbo inlet TD04 turbo evo 9 intercooler external wastegate n screamer pipe 14psi 8000rpm rev limit megasquirt ecu just pushed 200bhp at the fly after a kwik remap on the way down to L.A.D in morecambe! is getting turned upto 18psi n mapped as soon as L.A.D have a free afternoon for me to use the dyno! THE ENGINE HAD DONE 105000 MILES WHEN THE CONVERSION WAS DONE! NO FANCY PISTONS OR MODS! IT GOES LIKE FOOK N IT WORKS! NO SHINY BITS BUT AT THE END OF THE DAY ITS COST £800 U CANT BUY THIS TYPE OF POWER FOR THE MONEY ANYWERE ELSE!