exactly what my problem is
maybe this will help
The standard wiring is usually something along the lines of
Grey Wires = Lives (one is permanent and one is switched)
Blue = Illumination
Black or Green/Yellow = Earth
The rest are speaker wires
The positive will just be a colour and the negative will be a colour with a black line down the wire
Aftermarket wiring is something like this
Red = Switched Live
Yellow = Permanent Live
Orange = Illumination
Black = Earth
Blue or Blue/White = Remote (for amps)
The rest are speaker wires
The positive will just be a colour and the negative will be a colour with a black line down the wire
If the headunit loses its settings then swap the yellow and red over
all this was posted from a post on the forum mate so credits to Predator_R32
http://www.saxperience.com/forum/showthread.php?t=81707
i have the same prob but i think instead of soldering im going to snip then and connect the wires with connector blocks( terminal blocks)
