Quick update :-
Found some data (carn't verify it but its ment to be off autodata for a 97-03 vts ) so i cross check some sensors with my multimeter
Throttle position sensor
Component disconnected
terminals A & B Throttle closed 1000 ohms - 1500 ohms
I got (1415)
Terminals A & C Throttle closed 1000 ohms min
again around (1415)
Throttle fully open 3000 ohms max
and (2150)
Terminals B & EARTH with ignition on 5v
i also got (5v)
idle air control valve (i have 2 so i tested both)
disconnected
A & D 50 ohms
Number1 (43.8)
Number2 (44.4)
B & C 50 ohms
Number1 (No reading)
Number2 (No reading)
Dont know why it wouldn't read pins B&C, will have to look in to it
Intake temp sensor
1&2 10 degrees 3530 - 4100 ohms
1&2 20 degrees 2350 - 2670 ohms
1&2 30 degrees 1585 - 1790 ohms
1&2 40 degrees 1085 - 1230 ohms
1&2 50 degrees 763 - 857 ohms
I got No fixed reading at set temp- So a new Intake temp sensor is on the shopping list
I also tested my Water/coolant temp sensor (green one)
(2565) But i have no data to check this against.
So from this i now know i need a new Intake temp sensor and i have voltage at all my sensors so its not wiring related.
Probably wont be the single cause but ill get a new one and see what changes. Hope this mite help a few others as well.
|