Well since fitting the morettes it bugged me that the bottom cornors still stick out. So after some advice I checked to see if the rear clips where still attached which they were not so I brought some new morettes to use as parts.
When transfring the lens over to the new backs one went back toghter how it should. But the other was giving me trouble it seems its a diffrent mold than the others and would not go toghter the same.
So I cut the bit I was missing of the new back and am going to bond/fiberglass it on.
Pics of progress so far.
Broken clip missing
What it should be like
Cut out section of new back screwed into place still needs tweeking then will fiberglass and bond it on.
