Thread: My guide to COMPLETELY removing gear stick play!
View Single Post
Old 2nd October 2012, 20:13   #34
devilsadvocate
Saxperience Post Whore
South East Region Member
 
devilsadvocate's Avatar
 
Join Date: Dec 2006
Location: Maidstone
Posts: 8,210
Car(s): Golf TDI
devilsadvocate has much to be proud ofdevilsadvocate has much to be proud ofdevilsadvocate has much to be proud ofdevilsadvocate has much to be proud ofdevilsadvocate has much to be proud ofdevilsadvocate has much to be proud ofdevilsadvocate has much to be proud ofdevilsadvocate has much to be proud ofdevilsadvocate has much to be proud of
Default
Quote:
Originally Posted by LSOfreak View Post
so, just to bump this up
i changed the roll pin and used a drilled out washer as a spacer

how thick should it be? my washer was a standard washer thickness, whereas the one in the pic looks about twice the thickness??

its taken away the play, but not completely. would i be better off if i did it again and used 2 washers instead of 1, so to make it thicker?
If you can get the roll pin through with two washers then go for it. Are you sure the play is with the control arm and not within the box itself?

Sent from my GT-I9300 using Tapatalk 2
devilsadvocate is offline   Reply With Quote