Coming to doing my hubs, i was going to machine them too 33mm lenght x 37mm OD as this is the dimensions of the wheel bearing and use a 3mm spacer for the offset.
Or does the hub need to be machined so the back face/flange is flush but there is 2 faces on the back of the hub which are 34mm and 36mm in lenght. Guessing it will be the smaller one in diameter to be machined too but either way its going to be 33-34mm lenght.
If i dont find out this anwser i will just wait until i have my MA hubs off and use old bearing and the MA hub to go off so i get the right offset, etc.
The spacer dimension i will be making them too will be 37.1mm ID x 51mm OD x 3mm Width for anyone whos interested for future reference. This is so it is just in with the inner smaller wheel bearing which is roughly 52mm OD so it doesnt clamp against 2 seperate moving bearings meaning the spacer could get damaged or damage the bearing.
__________________
Quote:
Originally Posted by unreal106
Nah you want purple yo! makes cars go faster!!!!
|
Last edited by jsdvtr; 26th January 2013 at 11:16.
|