So with the fiddly bit over and done with all that’s left is to refit the new bits! As I’m waiting for my uprated linkages I’ve refitted the old ones for now, but the worst of the play was in the gearbox arm, the selector rod and the ball on the control return so with those all sorted there’s a massive difference. Not even sure I needed the uprated rods, but there is a tiny bit of play still in each one so I’ll still put them on when they get here just for the finishing touch.
So the control return arm and selector rod are fitted back together, all moving parts, cups and sockets are coated in grease just to make everything feel smooth:
Not forgetting to refit and tighten the diagonal brace to the wishbone mount:
The old gear rods all popped on by hand with a bit of grease, though I’ll fit my uprated ones as soon as they arrive. With everything reassembled and working fine the car can be dropped down and the inside put back together:
The quickshift adjustment is by the two locking collars on the lever. The lever can be set at any height in the housing to adjust the throw, I played around with mine to get it how I wanted it, then when I was happy a drop of loctite on each of the grub screws and a final tightening up made it nice and solid.
I cut the back off the old lever housing to act as the bracket for the centre console, with the housing and console re drilled it can be fitted back as it was before:
Then window switches, gaitor and knob back on with loctite again and that’s it!
The difference between the new and old gearchange is night and day, a massive improvement and definitely worth doing if you’re planning on track days or fast driving. I’ve never driven a Satchshift fitted car but with how this feels now I’m not sure I can see the point!