No need to cut wires, I did this mod and no difference fault still re appeared. I obtained a non transponder ign lock and switch barrel from e bay as an aftermarket aftermarket purchase. Split the lmechanical lock part from the plastic switch part which has all the wiring going into it. This can be separated by the external screw on the metal body. You will need a security screwdriver set for this. Remove the existing lock barell and switch on the car .take to bench and do the same split the mechanical from the switch. Put aside the switch part. Fit the new switch from the aftermarket to your existing mechanical lock barrel , reassemble into the steering column. I found replacing the cables the connectors were different colours but went with the cable wiring colours matching the existing harness. So far so good.You will need a security screw set to remove replace the small screw holding the ignition barrel in the car.
|