Here Ya Go...
1) jack the car up on one side at the front
2) put the car in 3rd gear
3) remove the rocker cover
4) remove the spark plugs so u dont have to work against the compression
5) now turn the road wheel in a forward direction to turn the engine to the correct position
and adjust the valves to the following specs:
valve clearances are- 0.20mm for all the inlet valves and 0.40mm for the exhaust valves
No.1 exaust valve fully open - adjust No.3 inlet and No.4 exhaust.
No.3 exhaust vale fully open - adjust No4 inlet and No2 exhaust.
No4 exhaust open- adjust No2 inlet and No1 exhaust.
No2 exhaust open - adjust No1 inlet and No3 exhaust.
so turn the engine so that cylinder 1's exhaust valve is fully open and ten adjsut cylinder 3's
inlet to 0.20 on a feeler gauge and then adjsut cylinder 4s exhaust prot to 0.40. then turn the
engine till cylinder 3 exhaust is fully open and so forth.
|