[Tom5190]

Fan wiring instructions:

1. Saxo - Using Mk1 radiator & Mk2 fan setup

First, on the fan open up the black box, there is one Phillips screw holding the cover on as you look at it from the front of the car.

You need to bridge the blue and green wire coming from the relay, once that's done put the relay back into the fan housing and put the cover back on.

Next you need to wire in an earth, there is an earth point just behind the battery tray or behind the headlight that you can use, just get a length of wire and attach a ring terminal onto the end, then solder this into the yellow/green wire coming from the fan plug on the radiator.

Next there should be a blue wire from the fan plug left, There are 3 wires going to the original fan plug on the engine loom these should be green, pink & yellow. You need to connect the remaining blue wire from the plug to the yellow wire on the original loom.

MORE TO BE ADDED