Hi all,
I'm gradually replacing/fixing various bits and bobs on a 1.1 Desire that we got for my daughter and I've got round to the rear brakes. When taking the drums off the wheel bearings on both sides came off in bits so I ordered up some new ones whilst replacing the cylinders and brake shoes. The drums were pretty grotty so got some new ones from GSF. I don't have a press so stuck the drums into the oven and the bearings in the freezer gave it a while then the bearings dropped into the drums without any issues. Only problem now is that they won't go back on the car and I have a horrible feeling that I've managed to install the bearings the wrong way round!
So, a couple of questions for you guys...
Is the little stub axle that the bearings sit on tapered? Does anyone know how to get these eyeless clips out of the drum? I don't mind sacrificing a couple of bearings but I don't want to lose the new drums. Finally, does anyone have a step by step guide (also known as an idiots guide) on how to replace the rear bearings so I don't make the same mistakes again?
Thanks, Lardy.