Saxperience - Citroen Saxo Forum - View Single Post - induction kit fitting , what to do with breather hose?

ManGo-SaXo · 2nd February 2010, 17:13

I'm looking at getting a breather filter for my Furio, im assuming 19mm is the correct size for the furio?

I have a K&N Induction kit so there is a pipe going from the rocker cover to the pipe that the air filter is attached, if i was to buy a breather filter for the rocker cover would it be ok to to put some strong tape around where the hole would be from removing the pipe that leads onto the housing for the air filter? If that makes sense.

2nd February 2010, 17:13	#15
ManGo-SaXo Frequent Poster Join Date: Dec 2009 Location: Shropshire Posts: 652 Car(s): 1.4 - FuriO iTrader Score: 6 (100%)	I'm looking at getting a breather filter for my Furio, im assuming 19mm is the correct size for the furio? I have a K&N Induction kit so there is a pipe going from the rocker cover to the pipe that the air filter is attached, if i was to buy a breather filter for the rocker cover would it be ok to to put some strong tape around where the hole would be from removing the pipe that leads onto the housing for the air filter? If that makes sense.