Saxperience - Citroen Saxo Forum - View Single Post - Using 1 plug sensors and 3-plug loom with a JP4

-Dan- · 7th August 2010, 10:32

I know it's advised that it's much easier to get the correct engine and loom type when doing conversions, however I just wanted to see if I could do the following.

If were to get a single plug J4 lump (which are much more common than triple plugs) and the loom/ecu from a 3-plug (which is what mine is), how much work is involved in getting them to work together with the JP4, considering all the sensors and everything need to be adapted/bolted on from the J4 to the JP4 (and will therefore be single plug setup) but the loom will obviously be the 3 plug setup.

I know this has likely been covered, but as usual the search function being utter gash didn't turn up anything worthwhile, so yeah - sorry if this has been covered before.

7th August 2010, 10:32	#1
-Dan- Established Member Join Date: Jul 2008 Location: Taunton, Somerset Posts: 1,182 Car(s): Millenium Falcon iTrader Score: 2 (100%)	Using 1 plug sensors and 3-plug loom with a JP4 I know it's advised that it's much easier to get the correct engine and loom type when doing conversions, however I just wanted to see if I could do the following. If were to get a single plug J4 lump (which are much more common than triple plugs) and the loom/ecu from a 3-plug (which is what mine is), how much work is involved in getting them to work together with the JP4, considering all the sensors and everything need to be adapted/bolted on from the J4 to the JP4 (and will therefore be single plug setup) but the loom will obviously be the 3 plug setup. I know this has likely been covered, but as usual the search function being utter gash didn't turn up anything worthwhile, so yeah - sorry if this has been covered before. Last edited by -Dan-; 7th August 2010 at 10:36.