Quote:
Originally Posted by AzzAW93
but if you were doing a full rebuild including new bearings and so on would you have stretched that little extra for decent race bearings? as they will be getting replaced no matter what
cheers  |
no need at your power /rpm level
same goes for arp con rod bolts
especially consdiering you can get forged rods with arp bolts for £350 --then £100 for bolts seems a waste
when have you seen a tu5 wear out crank bearings --
i have never seen it --unless there was another problem and then you would need a crank
crank bearings are same size as a cosworth !!!
If you are rebuilding because its knocking or using oil thats another matter
if not i would leave it alone and just fit your cams
oil pressure should be 4bar @4000rpm when hot