View Single Post
Old 14th February 2018, 20:33   #107
Chipwizards
Frequent Poster
 
Join Date: Nov 2009
Posts: 576
Chipwizards is on a distinguished road
Default

They are Megane 225/R26R injectors...
See the 8 holes in the end, how they are in two pairs shaped like ( ) ?
Well they should be level so that each half of holes sprays down each inlet port, as they are they will be spraying partly on the roof and partly on the floor of the port.
The injector needs to be twisted so that the connector is at an angle. The clips would hold them at the correct angle if they were in a Megane fuel rail, that's what the notch in the clip is for. They have probably been twisted around so the connectors sit straight and that has opened up the clip so they don't hold the injectors correctly any more.

If you don't like them there is a Bosch option which fits better but they are about £150 each.
Chipwizards is offline   Reply With Quote