-Loosen off wheel bolts when car is on ground and put into gear and put on hand break
-Jack up front of car and remove wheels
-Undo the brake fluid resivour(sp) cap and then leaver the front brake pistons back, I wedge in a screwdriver against teh back of the outside pad and the carrier
-When you get to the front calipers, there are 2 19mm bolts that hold the carrier and caliper to the strut, undo them and remove caliper, then swap out pads. Note those 19mm bolts should be in there pretty tight or even thread locked so have to give it some force to undo. The pads should just slide out, will be obvious when you have the carrier and caliper off.
(note when replacing pads, expecially with just cheap standard stuff it's best to do the disks at the same time, the disks should just be 2 torq screw holding them against the hub, t40 or t45 iirc although most cars don't have them due to being snapped off !)
To bleed the brakes you have to start at the furthest away from the master cylinder, so when looking at car, start with back left, then back right, then front left and finally front right.
-Bleeding is just a case of undo the bleed nipple on the caliper that you want to bleed and pump the brake pedal until a steady stream of fluid comes out. Note that you should only have 1 bleed nipple open at a time, don't bleed one caliper while having another calipers bleed nipple open.
|