ABS light problem

[DaCrazyOne]

So had light come on read code changed rear sensor that its advised drove round for 20 min still showing abs light on any idea what cause of this can be even tho changed the faulty sensor for new?

[Gabbastard]

Manky connections or bad continuity wire.

[axsaxoman]

maybe you changed wrong one at rear?
also you need to wipe the fault --it may eventually see its working after about 20 stop start cycles if you don,t wipe code.what id you code reader say when you interrogated it again after fitting sensor

[DaCrazyOne]

Originally Posted by axsaxoman

maybe you changed wrong one at rear?
also you need to wipe the fault --it may eventually see its working after about 20 stop start cycles if you don,t wipe code.what id you code reader say when you interrogated it again after fitting sensor

Well found another code on it reporting 194 motor pump and seeing this is the abs pump motor am guessing this has failed and needs replacing as clear code and instantly come back and abs stays on. Come son when switching ignition on then goes off for a split sec when starting then comes back on. am guessing my abs motor is shagged? Is the only code comes on now as all others now gone away just code 194 pump motor or motor pump

[axsaxoman]

check condition of wiring connector to pump --look for corroded pins

[DaCrazyOne]

Checked all that amd seems fine nothing bad on it n no corroded pins or anything. Also with the change of abs pump does this need re programming into ECU or is it a straight swap over and bleed of abs system?

[axsaxoman]

striaght swop I think