Small update...
Managed to get a free weekend to go and work on the car.
Started by finishing the intake off and fitting the new 90 degree reducer...
I modified the procomp a bit by removing the front panel and giving it a quick paint.
Before...
After...
When the bonnet is closed...
I then set about fitting the new TRS door pulls. The original ones I made from a pair of cheap dog leads were looking a bit tatty and were mounted too low. When you pulled the door closed, you got your hand trapped between the door and the cage.
Fairly straight forward to fit, just measure, drill, rivnut and then bolt them on...
The bend in the mounting plate matches the curve of the door nicely...
Next up was the dash centre. That was just a case of reattach the battery cables and bolt it in...
Pretty happy with how it looks.
That was it for work at home. I took the Satchshift base plate back to work to remake it out of carbon.
This is what the original looked like...
New aluminium tube for the rubber boot...
Marked up a bit of carbon...
Starting cutting it out...
All finished...
Pretty happy with the results and it's 280g lighter