Sooo..
Spoox Engine mount turned up today.
Brilliant service ordered sunday evening came wednesday morning, that was free postage too
Only issue is im not sure if the "chunky" side needs to be to the front or rear of the engine, will email them in a moment to ask.
So all was going well, then AAAARRRRRGGGGGHHHHH Wiring..... :'(
after stripping back all the tape i found these
After some inspection and a chat with jordon it looks like they arent needed, Phew!
kinda threw the loom in the inside, need to loosen off the heater matrix so i can feed the loom through it properly and mount it
Stripped back all of the engine bay loom, un-tangled it to get as much wire as possible too
Plans over the next couple days will be to tidy up the wiring and sort out a way to relocate the Omex to behind the dash.
Option 1. Cut all short wires that are not allowing me to move the omex and relocate it to behind the glovebox. Solder all the wires together again and heatshrink
Option 2. get a female and a male omex plugs and build an extention cable. so-to-speak, this option sounds a bit neater but we will see.
Going to do my best to hide or tuck any wiring but there arent many wires anyway since the majority were removed because of the omex.
fingers crossed all goes well
also just made sure my downpipe cleared my turbo
Oh and i lost the large fuse board that attaches to these
the one with the 10mm live feed. not 100% sure how i lost it, i cant find it anywhere!