Rear disc hub replacement
Hi folks,
Probably going to be doing nearside rear wheel bearing. I know from trying to remove the hubs off my old axle (disc hubs by the way) that they fall apart and leave the inner race on the stub. I also realise that the best plan is to buy the hub with bearing already in and fit that. As far as getting the old race off, I will probably just cut it off.
Thing I wondered was, is it easy enough to fit the new hub - given that the old inner race gets stuck on? Is the inner bearing on the new hub going to bind up ? Heat the hub perhaps before fitting?
Cheers
Craig
|