mamba it will plug in run but non of dials will work, its easy splice to do though if your slightly capable. just make sure you label everything both sides of where your gonna cut the wires just to make sure you dont get lost.
i have spliced single plug ecu with latest big plug/pin layout for 02 shell. also i have wired fan to work like the 3 plug type (no sensor in rad) and take it off signal change in thermostat wiring which makes it more fun(however that all works perfect) only issue with wiring is getting lambda sensor working, i do not even get an eml nd its not even plugged in currently.
problem with car is it runs fine(albeit poor fuel economy and power loss) untill 5-10 mins down the road it starts spluttering its arse off and WILL die once its started doing it.. you can nurse it along but its a pain in ass to drive. with constant re throttling and more than a few seconds on the clutch it will die
or you stop and restart car and it works fine again for 10 mins the repeats. hot or cold it makes zero difference. i didnt think lambda would cause the 2nd issue but since its not connected (i still have no eml light confirming it isnt) but the poor fuel economy and power is a given, simply baffled
|
Linear Mode
