Raunchz's 306 Rallye

[raunchz]

Hi all,

I've been on here for a while, I used to have the following car:







Rough spec of this was a '99 Saxo VTS, Jenvey throttle bodies, Piper Cams, Piper Manifold, Saxsport exhaust, Megasquirt plug 'n' play ECU, HiSpec 4 pots, Bilstein Group N suspension, Peugoet Sport 21mm torsion bars, Superleggera alloys and a Cobra bucket seat.

I broke the above for parts and bought a new Seat Leon FR+ for using for work.

I'm now in the position for a second car so have bought a '98 306 Rallye in Red. Not got many pictures but this is the best one I've got:



I've replaced the following so far as it was in need of some serious tlc when I bought it:
- Headgasket
- waterpump
- idler and tensioner pulleys
- lightweight crankshaft pulley
- aux belt
- full service
- both new rear calipers, pads and discs
- all new rear copper brake lines
- new compensator valve
- new battery

In addition to the above, I've fitted the following to uprate things:
- Magnex stainless exhaust setup - cat-back
- PTFE inlet gsket
- Powerflex Black rear lower engine mount
- SPA gauges (oil temp/oil pressure and water temp/boost pressure)
- OMP dished steering wheel





Future plans are as follows to try and make it a bit more of fun car to drive:
- Replace all of the suspension with new oem items
- Powerflex Black bushes were possible
- Uprated front brakes (going to fit some wilwood 4pots to oem discs so I can keep the cyclones)
- Quaife ATB LSD
- Take off and remount the front and rear bumpers
- refresh the gear linkage setup
- under-seal the whole car
- upper and lower strut braces (not sure that the lower will fit with the undertry)
- thicker rear ARB (maybe c.26mm)

Open to feedback and any suggestions on improving on the driving experience of the car, without going too hardcore.

Sent from my HTC One using Tapatalk