Saxo rear wheel bearings - Saxperience

Jonathancilia · 19th May 2018, 19:15

Hi im in the process of changing my rear drums and shoes, and i need to install new bearings to the drums,

Do i need 52mm or 51mm wheel bearings diameter?

Mine is no ABS and 4 studs 1.5 diesel

Sent from my VFD 510 using Tapatalk

Slevan_7 · 19th May 2018, 21:12

Just had a look in the Haynes manual it doesn't tell me anything, what I always do is get a set of calipers on the bearing before removal and after, you're ready going to have to find this out on your own mate not a huge amount of people on hear anymore.

Sent from my F8331 using Tapatalk

Jonathancilia · 19th May 2018, 21:15

I understand, i only asked because im not going to remove the old one because the drum is junk

I saw that there are 2 sizes, one 56mm and one 52mm. But i think i need the 52mm then because i measured with a set of calipers even if i had to eyeball it because the calipers wont go in all the way

Sent from my VFD 510 using Tapatalk

Slevan_7 · 19th May 2018, 21:24

If it's stuck I take it your not using it at the moment, just pull the bearing, I'm guessing if you'd already had a set on there saying 52mm a 4mm difference would be a huge amount of difference, I would just order 52mm bearing its not like there expensive really.

Sent from my F8331 using Tapatalk

Jonathancilia · 19th May 2018, 21:25

Thats what i will do thanks

Sent from my VFD 510 using Tapatalk

Slevan_7 · 19th May 2018, 21:34

I just had to find out what crankshaft seals I needed, I was 0.2mm off on the calipers so it's easy really. I know the feeling worrying about ordering the wrong thing, was all good in the end.

Sent from my F8331 using Tapatalk

Jonathancilia · 19th May 2018, 21:36

Yeah especially when ordering online you have to be super careful, because sometimes you give them all the correct information and they still send you the wrong parts hehe

Sent from my VFD 510 using Tapatalk