get one blanking plug and bung a front port, feed the fronts from two rear ports, and the rears from the remaining front port.
go from MC to a bulkhead fitting then to the bias valve then the Rear port of the HH, then from the front port to anoher bulkhead fitting, or a t piece then two bulkhead fittings, out to the standard clips, flexis to the beam, standard solid lines.
fronts can be standard solid lines and standard flexis.
this will give a very good pedal feel and be quite cheap, better pedal feel than full braided as PTFE hose does still expand a little under extreme pressures.
|