first off all you need to remove the saxo doorcard. take the 2 torx screws out
once the screws are out. go to one off the lower corners off the doorcard and prize it off. then start working your way round the doorcard till it fully comes off.
now lift the doorcard over the doorpin and the doorcard is off.
remove the L-shaped metal piece, as you won`t be needing it anymore
remove the inner mirror plate. this just pulls off
with the mirror plate removed you will be left with this. remove the screw the arrow is pointing at
remove the screw so you can remove the mirror plate. you now need the inner mirror plates from a 106 that has manuel mirrors and use that mirror plate. if you have a vts, you will need a mirror plate from a 106 with electric mirrors. mind put the screw back in when you`ve fitted the 106 plates
next is to remove these 3 bolts from the door lock. but keep them close as you will be putting them back in a minute
with removing the 3bolts it will now let you take the inner door leaver off and replace it with 106 inner door lever. the door leaver just pulls out and unhooks at the back. then fit the 106 door leaver and put it back in , refit the 3 bolts in the door lock, the ones you just removed.
next step is to put the 106 doorcard in place. it goes over the doorpin and hooks in at the top. fits straight on
you will see in the above picture marks off where the doorhandle is to go. so get your door handle put it in place and drill 2 holes . these holes are at a angle so you will need a decent sized drill piece. holes are marked below. you will need self tapper screws for this job
this next part just pushes on below the door handle
this next part is held on by screws. ive outlined the screw fixings. it pushes on below the part you just put on. once fitted drill the holes i outlined and attach using inch self taper screws.
last part is to fit the inner door lever surround. this pushes straight on and clips in.
you should now have something that looks like this.