With the LC-1, dont run the standard lambda sensor, unplug it from loom and get rid correct?
Then run LC-1 lambda to the boss in exhaust, that correct?
(never been that good with understanding wiring)
Ill be running a predator ecu, so the wires from the LC-1 ( 6 wires)
1) Red to a 12v feed
2)Heater ground- Earth?
3)system ground - Earth again?
4)Analog out 1-- Where does this go?
5) Analog out 2-- Where does this go?
6)Calibration wire- goes to the push button then to a earth point
Its 4 & 5, im unsure about?
One of them to a gauge? and the other?
Isnt the Lc-1 wired to the ecu at all or is it seperate to the ecu?
Thanks