Driveshaft length - 1.3 rallye - Saxperience

steffeen · 11th September 2019, 06:46

Hi guys
I have a peugeot 106 1.3 rally from 1994 I use for tarmac rally, and I was so unlucky at breaking the driveshaft during the last race in the weekend.
I took it out and saw it was broken in the wheel side, and I'm looking for a replacement but I cant find the right one.

The length doesn't fit, I can only find 609mm driveshafts for driver side and the one I took out is 645mm but every tooth count etc fits.

am I measuring wrong or not? I measure from end to end on the driveshaft.

Vin number is VF31CMFZ250697415

Best regards

MartinObviously · 18th September 2019, 22:04

They're not set lengths, they're max/min lengths - the inner CV is a big spring to allow it to change length.

All the left side driveshafts are the same length, give or take a few mm. just make sure you buy a non taper type and you should be good to go

welshpug · 19th September 2019, 22:44

quoted measured lengths are fully compressed.