be gentle its my first time fabricating anything.
basic box with temp display and 2x80mm fans at front and 1 80mm at rear and window in the top with led fans and a hidden neon tube.
the base is 1inch thick mdf and the sides are plywood
the base had motherboard pillars/risers screwed into it and the mobo sits on those the same as a normal case.
the sides were initially screwed in then fibreglassed to re-inforce it
these are the first pics i had taken when the front and back fan holes and the temp display
test fitted the fans etc with a little bit of carpet i had bought and they were a nice fit so onto the carpeting.
I thought this was going to be easy but i was wrong. Damn it was annoying trying to work it out so there wasnt any folds etc because ot the diagonal front
still isnt perfect but its ok, it is trimmed in the same carpet that i have for my boot install which should be fun...... not!!
heres a pic of it carpeted with some old fans (awaiting on my led ones)
they are in the wrong way so they are blowing and not sucking and look crud but that will be rectified when my new ones come
Window
Heres a pic with the temp display on and functioning
another of the side of the case with the i/o panel
crud picture i thin i put a fingerprint on the lens
as you can probably tell im new to this.. any tips feedback is appreciated
will get pics up of the new fans and lighting when they arrive