Updates:
Backbox height temporarily fixed
New rubber gasket
Sprayed rocker cover temp
Apex sticker
Before I got the car lowered or lowered at the front :L I sorted out my exhaust as it was really low
wasnt like then when I put it on, so read up some comments on here and a good one was tie wrap it soooo I did
TODAY:
I changed the rubber gasket (think thats what it is
) as the old one had loads of cracks in it.
While I was there I sprayed it black with left over spray I had, I wanted to get an idea of what it could look like if I done it properly. I no it will eventually come off but when It does I will get some heatproof paint ect and do it properly but was mainly focused on the rubber bit.
O also shows my new ecu cover
that I purchased of VTRacer
Rocker off (Again,, as I usually say ignore the stupid big white pipe and stupidly big air filter :L looking to get it changed)
Personally think it looks good with it black, like I said was just a really quick job, didnt bother sanding it down or whatever and used up my last little bit of black so its got one coat aha, I scrapped it earlier and some came of so it was a crappy job
Went somewhere with my brother today, took a quick snap
Doesnt help its near a nice big car
y
Linear Mode
