Right, C2 inlet is causing me some headache
but in the process of sorting that!
Been to the breakers today and managed to get a few bits and pieces that i was after!
In the next couple of weeks will hope to have the engine in
then will sort out intercooler size/pipeing Fit the Rad and work out where to put the oil coolers
The to do list is shrinking at a good pace to
Left to do -
Clean Engine Bay and Repaint
Make Adaptor for J4 body to fit C2 inlet
Get BTB mani adapted to fit the 2.5 inch exhaust
Fit Suspension
Fit GTI-6 front Brakes
Fit Polybushes for wishbones and ARB
Trim and refit Dash
Change Flywheel so i can fit the Clutch
Fit Guages and takeoffs
Refit the engine
Get the Dta Fitted and loom adapted
Get the Lc-1 up and running
Left to buy -
Injectors
Coilpack
Fuel Hose
Guages
Grp A lower bush
Intercooler and pipework
Pipework for rad
Oil Cooler
Drive Shafts
Box oil
Engine oil
Charger oil
Slimline Fan
A few hose clamps
Discks and Pads
Charger Belt
Its getting there!