Whats next.

[vtrlogan]

im hoping this hasnt been asked that much but,

what else can i do 'cheaply' now?

my spec is

Side exit exhaust (de-cat MABEY)
polished throttle bodys ( power increase on just them was :O)
enclosed induction kit

So where do i go now? does it have to be cams and re map or? and cheap way off getting small gains?

just like to say any one that wants there throttle body polished go to cammed_spencer BRILL job :D

[joevtr01]

what u after performance or looks

[vtrlogan]

performance i no i int gunna get 10+ bhp for any thing cheap but i not sure if i wanna cam and start doing wild engine mods because its up to like 90k on the clock.

[L8R_VTR]

spence now does ported inlet manifold this will give you a better gain than the trottle body i would of thought mate!! have you a branch manifold??

[spanair]

If you are going to cam it then you'll want re mapping so it wont be "cheap" but if you are going to do that polish the inlet manifold and add an after market outlet manifold :)

[L8R_VTR]

also a de-cat yeah that helps a little around about 5 bhp if nyou have a full system!! p.s if you want cheap power strip the interior out of the car and save all the weight that you can bud!!!:y: :y:

[gazza808]

before you think of cames and what not, jus remember you may as well swap to a vts,

or put a vts lump in yours, cheapest bang for you buck

[vtrlogan]

spence now does ported inlet manifold this will give you a better gain than the trottle body i would of thought mate!! have you a branch manifold??

o i will have a word again. i couldnt belive how much just that throttle body makes, cheers ;)

[vtrlogan]

spencer_cammedvts just wanna say pm him if you want your throttle body done :D bril service.