mada
28th May 2008, 17:17
i finally got my vtr lump plumbed up and wired in today, i removed the immobiliser code box and transponder and tried to start it up. it will started then cut out after a second or two.
if i move the little clip on the throttle cable along a few notches and try again, the engine just shoots right up to the limiter, at which point i switch the ignition back off as i didnt want to ruin the engine.
anyone have any ideas as how to sort this out?
cheers
adam
if i move the little clip on the throttle cable along a few notches and try again, the engine just shoots right up to the limiter, at which point i switch the ignition back off as i didnt want to ruin the engine.
anyone have any ideas as how to sort this out?
cheers
adam