PDA

View Full Version : motor bike exhaust

martyn_roddie
17th July 2008, 15:56
can anyone give me a ruff ideawhat i would need to a motorbike exhaust to my saxo vtr?
Saxowesty
17th July 2008, 16:22
why would you even wan do that? or is it just me bein stupid?
Daffron
17th July 2008, 16:23
Do you mean throttle bodies? Expensive but pro!
martyn_roddie
17th July 2008, 16:28
nope a bike can fit on to 106s and saxo1 and sounds good few of my pals old car had it done
don55
17th July 2008, 16:41
buy a bike can, cut of your back box and weld in a new one.

i really cat see why on gods green planet you would want to, but thats your prerogative
Aron
17th July 2008, 16:42
all you would need is the can and some hangs to mount to the can. then just need a descent exhaust builder to mount the can to the center pipe.
Aron
17th July 2008, 16:43
it would sound pretty good to be fair. would be complety different sound to the norm
martyn_roddie
17th July 2008, 16:45
that the all whole point i dont want my car to be the same as very other saxo
don55
17th July 2008, 16:54
why not mount a shed on the roof, or run it on 8" wheels :D

to be honest, its been done before and is very, very 5 years ago.

only one i have seen that looked good was a vts that had the rear part of the rear bumper cut out, where it dipps in, then had it mounted in a recess in the centre.
martyn_roddie
17th July 2008, 18:17
a know it has been done before and might be 5 years ago but its my car and i can do what i want with it mate
MikeReay89
17th July 2008, 18:26
They sound good few of my mates have had on previous cars
Dasher_VTR
17th July 2008, 19:01
i heard one on a 106 and it sounded shite TBH.
kev999_VTR
17th July 2008, 19:05
Seen one on a civic before, looks and sound wise = crap!
Just my opinion though!
McBain
17th July 2008, 19:22
Remember most bike cans are stainless so may be a bit tricky if your no good at welding and planning on doing it yourself.
If you really wanna chav it up go for a carbon one:y:
David
17th July 2008, 19:25
that the all whole point i dont want my car to be the same as very other saxo

a know it has been done before and might be 5 years ago but its my car and i can do what i want with it mate

So you want something different that's been done before... Riiiight... :S
flee123
17th July 2008, 19:37
I might try jamming pop bottles between the tyre and the body like I used to do with my BMX. Make it sound like a bike ftw
DaveyBoy
17th July 2008, 21:02
the motorbike back cans look good if fitted properly... this is what you will need;
exhaust putty
maybe a universal flexi hose.
universal mounts(rip speed sell them, halfords, car spares, GSF)
if u had a plasma cutter the job would get done a lot faster.
but take ur time, never cut too much and the actual pipes from the back of the middle section to the bike can should fit quite well, obviously depending what bike its from.
im looking for a bike can for mine cos i do love the look.
good luck wth it mate