M10x150mm Bolt

[Liam]

I can get a bolt from a hardware store, but should i just get the bolt from Cit? It's easier if i get it from the hardware store, but im not sure if it will do the same job. Same bolt though except from Cit they are torx rather than a normal bolt.......

[cj_99]

Am i assuming this is for the return oil feed when changing from mk2 to mk1 setup?

Just get it from the hardware store would be no different in having a bolt head on it than a torx

[Ross170889]

Mate u can just get one from a hardware shop i did

[Liam]

No its for the Top VTS engine mount.

[swampy]

No its for the Top VTS engine mount.

then make sure its the correct tensile strength

id say you would want 10.9 or 12.9 for that application

is it a bolt with a part thread or a set screw with a thread all the way along the length??

[Liam]

then make sure its the correct tensile strength

id say you would want 10.9 or 12.9 for that application

is it a bolt with a part thread or a set screw with a thread all the way along the length??

Judging by the picture its all the way along the length.

[raunchz]

Maybe easier to order them from Citroen? Then you can guarantee they are the right ones, the correct length, tensile strength etc.

Shouldn't cost a lot!

[Liam]

Maybe easier to order them from Citroen? Then you can guarantee they are the right ones, the correct length, tensile strength etc.

Shouldn't cost a lot!

£1.25 each. But i guess your right. Just lookin for a quick fix

[raunchz]

I wouldn;t go for a quick fix with regards to engine mounting bolts.

Maybe if you were looking for bolts to hold you induction kit on, but engine mount bolts . . . . .