had my car mapped amazed at power 157.7bhp!!

[jzink]

I cannot thank wayne from chip wizards enough!!! He mapped my 2001 Y reg vts, 3 pin ECU saxo which toke him 5 hours to properly and got me an amazing 157.7bhp!! He is one of only 2 place able to map these and i would never go anywher else first trip was a night mare toke me 3hours towing car from b'ham to find that my newly fitte ported and polished head was leaking he looked at it for free and diagnoised that it was the Head gasket. Then as i am going to Olton park tomoz he agreed to map it on saturday just gone, I have a BMC filter, newman cams, Magnex 4to1 manifold and stainless system and was hoping for 150 at a push! He knocked me a massive discount of for being in this and saxosports club and even ported and polished the butterfly value on throttle body, which gained the final 3bhp to make the gains! If anyone is thinking of getting car mapped I couldn't recommend him higher he is down to earth honest and worth every penny. I am very exicted about tomoz as long as know snow as my car is running just shy of 200bhp per ton, as is stripped with 10 point pug 106 cup car roll cage harnesses and bucket seats! ANyone on here coming tomoz??? Will post piictures of car when go tomoz

[JamesR]

nice figure that mate, you should be proud of 157bhp, no other small little job just to get it to 160bhp? i would be very proud of that figure mate, what newman cam have you got?

[Sparco_Tom]

sweeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeet nice figure

[jzink]

think they were phase 3' or 2 mate not 100% bought them new with ported and poliched head of ebay

[jzink]

iam chuffed with figure loads of guys on here said i wouldn't even get 150bhp wayne is so good at mapping!!!!!!!!!!11

[qrty]

How much was the mapping?

[DanT]

That is a nice figure mate, something to be proud of for sure! Nice one.

[jzink]

I paid a good figure that can't disclose but you pay just £450 plus vat worth every penny for my extra 30bhp

[Shellz]

Nice! :D

[JamesR]

so you got an extra 30bhp off a remap? dont think thats quite possible.

[jzink]

Ran 131 bhp with inlet can retarded 3 degrees to run on standard ecu with all other mods the made 157.7bhp when mapped can prove with print outs! Why would I lie come to olron park tomoz and you'll see mate

[JamesR]

thats a pretty amazing figure, i would of paid up to £700 for that, 30bhp is a good increase.

[jzink]

It only just ran on standard ecu as ticked over at 1400 to 2000 rpm's to work. Mappin diesel turbos often see gains of 50bhp plus going to sleep now as got to be up at 4.30am for trackday. Ask aldon automotive they fitted cams head and couldn't map with piggy back and gave rolling road figure originallyn aldon are in breily hill, dudley.

[Ryan]

waynes rollers allways read a few higher than most places it seems.

yet the cars seem to be capable with the maps produced.

[GTiGuy]

Excellent gain there..

[jpsaxo]

good work mate, sounds like a good overall set up :D

[saxo_ron]

Yeah mine was mapped with Wayne and he did a spot on job. No issues with my map or running problems and its nearly a year now.

Good figures mate, take them with a pinch of salt but you will 'feel' the difference.

[jzink]

definately geniune figure as had no probs over takin civic type_r and 172 cup at olton park and cilstiens are brilliant for handling will post photos later

[williamsvts]

i paid £370 iirc,
mine has a slight stutter at about 1.5k, been like that for the last couple year.
dont know if i would go back to him for mapping though??? only if i was sticking with OE ecu.

[leeroybrown]

708's aint you run aint it Mark?

2 of my good mates have had the same problem...cough on abit around 1.5k

[Alexvtrmk1]

Nice1 pal thats really good

[williamsvts]

yeah 708s, are they both 3 pluggers?

about 1.5k its a bit hesitant,

[leeroybrown]

1 was and 1 wasn't

[williamsvts]

ah right, i knew a lot of 3 plugs with his maps were hesitant at 1.5k

[leeroybrown]

only every now and then it does it

Only seem to be with 708's

Newmans seem fine

[Toad]

708s and mk2, and I have a the same issue in between 1 and 2k.

[saxotourdecorse]

where is this wayne dude situated, and how much, mine needs mapping.

[jzink]

Have you spoke to wayne as he'd probably fix it for free or may be a fault code given from the cam sensor hence splutter low down rev range. Prices will go up each year mate and I paid very little more than you and had butterfly vale ported and polished for free as have a known knife edge and to help tick over!

[williamsvts]

saxos dont have cams sensors.

[jzink]

Sorry meant fly wheel trigger sensor this will cause a random misfire reading and the engine management light will come on! Does it do it on tick over mostly if so this is what it will be mate

[Toad]

Wayne's mapping caused my engine diag light to come on. We looked it up and it refers to (IIRC...) It was P0606 - PCM/ECM processor malfunction. Nice... :fcuk:

Every time we cleared it, it came back on after a few dyno runs. It's been like that ever since. Wayne claimed he's never seen it before, but I'm not so sure... :detective:

[williamsvts]

engine management light has never been on and tick over is fine. its only at 1.5k. it only happend after it was mapped.

[leeroybrown]

Be interesting to see if this is only people with 708's that has this problem

[Toad]

engine management light has never been on and tick over is fine. its only at 1.5k. it only happend after it was mapped.

Probably only affected the 3 pluggers. The DTC that is...

[Toad]

Be interesting to see if this is only people with 708's that has this problem

Maybe. But at the end of the day, with 708s, the engine shouldn't run well below 2k anyway... Hmmm.

[williamsvts]

mine drove smoother unmapped lol

[pug205gti87]

where abouts in brum you from jzink??? u should pop round to mine an show us the car :P

[Toad]

mine drove smoother unmapped lol

Seriously?

[kieranc07]

might be just the way i drive but my the time ive prodded the throttle couple times then let out on the clutch its past 1.5k ? :)

kieran.

[jzink]

where abouts in brum you from jzink??? u should pop round to mine an show us the car :P

i live in great park whihc is on border of northfield and rubery! You are welcome to see the car but would have to come to mine as its a track car no tax or insurance altough still has mot mate