Resetting ECU

[Barry123]

It's just a case of disconnecting the bastard thing for a day or two isn't it right?

Will it remove fault codes as well?

muchious grassy arse

ads

[b0t13]

open door six times, spin round on one leg then hold your nose for 3 seconds.

if that doesnt work then i dunno, think its just a case of leaving it like you said until its power has gone..

[dinga]

yea half an hour is enough.

[Barry123]

open door six times, spin round on one leg then hold your nose for 3 seconds.


only opened the door 5 times :wall: dammmmm it

[shaunyboy]

jus disconnect battery overnight, sometimes it works, sometimes it doesnt, mine was off overnight 2 days ago and it didnt take the MIL off. Same with SRS control units they have resistors in that hold alot of power once the source is taken away. best bet is to unplug the ecu its self and try that overnight or jus get it code read. if theres a current fault, after a complete drive cycle the MIL will come back on and your back to square one. if its a stored fault then it will stay off.