Pipe coming from head? Help please

[dan-vts1]

Noticed off the back right corner of the head there a pipe on an elbow was out. It's about 2inch below the 1 from inducion kit to he head. I pushed back in went for drive checked and was back out. Any help cheers

[RJ303]

Pics - where did you push it back into?

[JamesR]

Does it come out of the rocker cover? If so its the oil breather pipe.

[SteveWC]

Yeah, its probably what saxo_vtr123 said, that pipe just places the hot oil vapours back through the inlet with the air intake, and burns them up in the cylinder. you can put a breather filter on the end which is better for your cold air intake but worse for the environment

[RJ303]

Might also be the crank case breather...?

[JamesR]

Might also be the crank case breather...?

Thats what the breather filter is ;)

[RJ303]

Thats what the breather filter is ;)

On mine I have a rocker breather and a crank case breather which were both fed back into the throttle body inlet... mines a 90bhp VTR the later ones only had a rocker breather going into the throttle body.

[JamesR]

On mine I have a rocker breather and a crank case breather which were both fed back into the throttle body inlet... mines a 90bhp VTR the later ones only had a rocker breather going into the throttle body.

Crank case and rocker cover are the same thing arnt they :wacko:

[bytor]

Won't affect the running of the engine, if you cane it you might get a bit of oil out of it no big deal.

[SteveWC]

On mine I have a rocker breather and a crank case breather which were both fed back into the throttle body inlet... mines a 90bhp VTR the later ones only had a rocker breather going into the throttle body.

mines later model and has two pipes going to the inlet

[dan-vts1]

i jus pushed back into the only hole could have come from lol went for drive again dn stayed in will check tomorrow but i think will just be a breather pipe but got no way of fastenin in securely anyway. come from below other breather round front of block and down the bottom somewhere