Sump bolt torque

[blake1312]

How many newton meters does the sump bolt need to be done on a 1.1? and prusme citroen sell the new washers?
Cheers

[Sparco_Tom]

sub bolt being which bolt?

[chris59]

think he means sump?

[Sparco_Tom]

if thats the case, just reuse the old bolt and washer. Tighten it in fully by hand then a good half turn is normally plenty. Just judge by hand

[yr51ocw]

sump bolt is 8nm

[Tontsy]

sump bolt is 8nm

hmmm... thats less than finger tight.

[blake1312]

hi yh bit of a typo soz and cheers for the help sparco tom, 8nm does seem a bit low buddy....

[Toms112]

What size are the bolts? I would of thought if M8 it'd be 22nm and if M10 about 30ish

[blake1312]

Well i have heard its a 8mm square socket needed 2 remove it correct me if im wrong

[Tontsy]

i cant be bothered to scroll up again, but i beleive tom has said, tighten it up, hand tight, then half a turn again... that would be spot on...and around 28-30Nm anyway.

[blake1312]

Ok cheers mate, also anyone no rougthly how much oil i will need to fill the 1.1?
Cheers

[wanabevtr]

you need 3.5L of either 15-40 or 10-40 oil plus a filter, a new washer for the drain sump and you will need a sump key and a oil filter wrench

Remember to recycle the used oil and don't dump in in a drain ;)