engine rebuild

[dellboy]

any1 fancy rebuliding my vts bottom end

[raunchz]

You physically just need it assembled? Got all the parts?

[Mochachino]

No.

Do it yourself and learn a thing or too, Haynes will be handy.

[dellboy]

were is the best place to get new parts from

[raunchz]

gsf, eurocarparts, Citroen

[Aron]

Parts all depend on if you want standard set up or uprated?

[dellboy]

so no1 is doin this as a side job

[raunchz]

what do you want replaced?

New pistons rings? Bores need a hone? New pistons, bearings? Seals ?

[Sparco_Tom]

Like Ross says what do you actually want doing? I've rebuilt loads of these engines could do it for you and supply parts

[dellboy]

just recon it with standard bits

[AndySAXO]

where are you from.

[dellboy]

southampton pal

[Sparco_Tom]

break down of what parts you want and what work would be nice

[dellboy]

i want the bottom end of my vts rebuilt , pistonrings,seals, bearings renewed

[Sparco_Tom]

bores honed? oil pump replacing?

[dellboy]

bored hone? huh and yeah please

[AndySAXO]

bit too far pal good luck.

[dellboy]

may deliver what u chargeing

[adzvtr]

southhampton a couple hours from me, deliver with parts i will do it.
how much u looking at. check my thread for my progress if ye want an idea wats involved

[AndySAXO]

would cost alot for me to do.

[dellboy]

prices

[chinkostu]

normally mate you should know what you want replacing before you go asking!

[adzvtr]

crank check £20.00
main bearings £75.00
big end bearings £32.44
piston rings £27.21 x4 total 108.84
large crank seal £18.20
small crank seal £10.67
honing of bores £10.00
labour £125

total £400.15

[Sparco_Tom]

Bargain

[dellboy]

wicked ill have a think thanks a lot every1 for the help