exhaust bending

[saxtreme]

befor i start if u ent gunna be helpfull dnt bother comment sayin lol at this guys post had anoth of it all

rite basicly i tryed what some told me to do which is this (wooop wooop now sorted this out )

http://i998.photobucket.com/albums/af105/saxtreme_2010/21042010041.jpg

which at the time lookd as if it would work got the decat drom (sexy gt .. thanks alot realy pleased with it ) but as you can see its lil far back

with it all fitted it is like this

http://i998.photobucket.com/albums/af105/saxtreme_2010/21042010042.jpg

http://i998.photobucket.com/albums/af105/saxtreme_2010/21042010040.jpg

http://i998.photobucket.com/albums/af105/saxtreme_2010/21042010043.jpg

how am i goin to put a braket here to fit it so holds up( sorted it )

and last thing is on this join it some how needs holding up as the join bends down quite abit (hence the jack holding it up

http://i998.photobucket.com/albums/af105/saxtreme_2010/21042010044.jpg

http://i998.photobucket.com/albums/af105/saxtreme_2010/21042010046.jpg

was looking and saw this would it be possible to make a bracket to hold to this part

if i got a big enought menat lclip thing (forgot the name ) would that hold it up

http://i998.photobucket.com/albums/af105/saxtreme_2010/21042010045.jpg

[Rez]

Hi mate you could try your Thompson local etc for a Mobile Welder who'd come out cut the hangers off and weld them back on for you. They would probably weld a bracket on on the right side for the other box and usually they don't charge much. Give a few a ring and get some quotes at least it won't fall off after.

[saxtreme]

every thing issorted nowapart from the bending on that joint couldi put ametal clip for now untill i can get a bracket made for it to hold it up to the spare tyre rack were it used to be

[adamskiTNR]

You could use a sleeve fitting. Then the join wouldn't bend at all, it would be like one pipe

[saxtreme]

thats wat has been done but not strong enuff

jus need to hold it up secure not to take any wieght