Log in

View Full Version : mk2 head, on a mk1 block, in a mk 1 vts

TforTurner
12th July 2010, 17:28
Just a quick question,

Will I have issues with fitting the above?
If so, what do I need to consider? It's a single plug ECU.

Any help appreciated!
bluenotesmiley
13th July 2010, 01:46
The heads are identical AFAIK as I have put single plug and 3-plug engine parts together. I remember one of the sensors being different on the throttle body, I think it was the TPS, the plug is different. There is also a different thermostat and coolant temperature sensor setup but I assume you would just be using all your old ancillaries from the current setup not from the new head.