help - vtr cylinder head query!!!!

[Mathias]

I have an issue, i need to fit the rallye inlet and its proving ipossible to make it fit the silvertop head, my problem is i have a fully built up silvertop head on my engine, im now going to remove my head and build a good spec blacktop head, the question is:

will all my valves/springs/caps that are fitted to my silvertop, fit the blacktop head?

will i have any clearance issues using the silvertop bottom end and the blacktop head?

[raunchz]

Just putting it out there, how about getting some sort of custom inlet made up? :P

[Mathias]

Thats the other thing ive considered, only other pain in the arse is that the boost pipe etc has been measured up ready for the s1 inlet, but im sure if i gave bogg brothers a call and explained they would be able to do something, but what about

- throttle body?
- throttle cable?

[raunchz]

Throttle body - ATPower 55mm unit

^^ it comes with a bracket for mounting the throttle cable.

I don't know about the cost of building up a mad blacktop head? If it's half the cost of getting an inlet made up then I'd be tempted, but won't you need basically all new head internals?

With the custom inlet you could have the boost pipe and vacuum lines etc anywhere you want :p

[blackie_2k5]

my head aint a blacktop mate, its a silvertop 90bhp, the rallye inet fits this ;)