lamba wires

[boony]

Is it ok to extend the wires on the lamba sensor , on my 4 -2-1 manifold the plug is at the bottom instead if half way up .

[tom_lloyd_4]

not ideal but if you do extend the loom not the sensor as the wire on the sensor is steel and wont solder and make sure you get a real good solder joint as they run a 1.5 volt signel and ity wont take much to mess the signel up
i would sugest geting a lamber for a mk1 and cuting the little lug off the side of the plug
hope this helps Tom