TimImg / locking tools

[DavidKent]

As above, did a search, can't find anything...

Need to have a mates cambelt off but cant find any locking tools for the pulleys.

Any suggestions / tips?

Cheers

[Heftydanielson]

once it's at TDC you need a M8 bolt into the pulley hole then in the engine side by the gearbox there is another hole for the flywheel lock.

[Bensvts]

use drill bits mate.. think its a 8mm drill bit in each pulley and then for crank down by were the dipstick comes out the block to the right theres a hole and think its a 6mm drill bit or just paint it up...

[Slugshead]

Yeah and the square pin from a door handle :)

[tarzan]

invest in a haynes manual mate

[Tontsy]

soopagloo!

[DavidKent]

Done, 2 8mm and a 5mm drill bit :)
Cheers