Enclosed induction fitment?

[Saxo_Wilson]

Hey,

I have just fitted an enclosed induction kit which i received today. Does the fitment look correct?

Part of shield is touching the manifold heat shield (As showing in photo). I am worried it will melt, but it doesn’t want to budge from that position. Any tips?

http://i6.photobucket.com/albums/y220/ihaveblades/enginebay2.jpg

http://i6.photobucket.com/albums/y220/ihaveblades/enginebay.jpg

http://i6.photobucket.com/albums/y220/ihaveblades/enginebay3.jpg

[ets2k9]

Mine doesn't sit much better than that mate. I'm not sure what else you can do without buying a new pipe or silicone hoses.

[SteVTR]

mine sits abit better than that because i dont have the egr valve anymore

i have got an idea on how to get mine to fit abit better and be abit better attached when i get round to doing it i'll put some pics up

[Saxo_Wilson]

Cheers mate.

Was it hard to remove the valve and did it make any diffrence?

[SteVTR]

dont think it makes any difference and i couldnt tell you how hard it is to remove as it was removed when i got the engine

[Saxo_Wilson]

I have managed to lift the kit off the manifold heat shield. I have used a cable tie to lift it off the sheild.

http://i6.photobucket.com/albums/y220/ihaveblades/enginebay4.jpg