cross over loom

[06gunnj]

just bought a cross over loom for my 1999 vts engine to go in my 2002 saxo furio, will i have any problems with my dials, or the mk2 radiator fan setup or anthing like that?, cheers

[blackie_2k5]

thats confusing to read...

and yes you probs will have probs, not just with that though, the crossover runs a different pin out to the later model saxos at the chassis side

if you unplug you furio loom at the chassis end and compare the pins that have wires attacthed on the two diff looms youll probs notice that its a totally diff set up :y:

[saxo-parts]

so your trying to run a single plug engine with a crossover loom in a 3 plug car? why not just get a 3 plug S loom?

[06gunnj]

couldnt find a 3 plug 1 and that 1 came up, and saves having to get a coilpack alternator and that, would it work if i matched the wires up to the right pins? or does 1 have more wires or at to the other?

[06gunnj]

any 1 help? wanting to make do with what i got

[sam_16v]

as said mate see if the interior plug matches you will find it in your drivers wing

[06gunnj]

the plugs are the same but some of the pins dont match up.. is any1 able to move the wires about to the right pins for me? or will it still not work that way?

[06gunnj]

or has any 1 got a guide to do it? , cheers

[rorz_vts]

Look though this section it was covered yesterday in another thread

[citroen_saxo_vtr]

I put a mk1 vts engine in my 3 plug mk2 furio with a mk2 3 plug vtr loom.......... it plugged in and ran but no dials etc so we cut the plug off the furio loom and cut the vtr loom plug off and tested and wired my old furio loom plug to the vtr loom so i have a mk1 16v engine in my 02 furio with a custom loom :D its all spot and been fine since.