lambda sleeve on saxo vts 2003

[tomo1989]

Hi,

Ihave bought myself a supersprint centre race pipe and piper back box which has decatted and desilenced, and after a few days the ECU came on so have bought the lambda sleeve from Kam Racing:y:

Now fitting i know i may get a few smart answers but what is the bes way to go about it do i keep the plug in one end of the sleeve and put the sensor in from other and screw in and mount under car in cable loom? then bung lambda hole up with bumng i got with the pipe?

Any help appreciated thanks.

Tomo:hug:

[tomo1989]

bump :)

[Sophia_Bush]

put bung back in the mid pipe, sleeve on the sensor then cable tie it to battery tray like I showed you

[KamRacing]

Its a Lambda sleeve and a bung to block up the exhaust - two separate bits but we put keep them together by screwing in the bung in the end...

Kev

[dolby20]

Its a Lambda sleeve and a bung to block up the exhaust - two separate bits but we put keep them together by screwing in the bung in the end...

Kev

I made this mistake :P
One is the sleeve
The other is a bung
Sleeve the second lambda and cable tie it out the way, plenty of room!

[tomo1989]

okay so i have just had it fitted on car put the bung in pipe and cable tied the sensor with the sleeve on it how long will it take for engine management light to go off?

Thanks for help guys!

[PastyVTR]

you will probabaly need to disconnect the battery, to reset

[RyanSaxo]

okay so i have just had it fitted on car put the bung in pipe and cable tied the sensor with the sleeve on it how long will it take for engine management light to go off?

Thanks for help guys!

it wont.

I even had mine reset at a garage. Came on again after a few miles.

I had a lambda sleeve on mine from day 1 of fitting the centre pipe and the light came on pretty much straight away after a drive.

Just have to put up with it.

[Sophia_Bush]

it will go out as said when I saw you, but can only tell you mine was ok with the sleeve even when on boost

[tomo1989]

I dont understand some work some dont do i just wait a few days now and see if it goes out? and will it run better or worse now its got no 2nd sensor in pipe?

thanks for replies guys appreciated! :)

[tomo1989]

it will go out as said when I saw you, but can only tell you mine was ok with the sleeve even when on boost

Its still on is the light from yesterday dinnertime when it got fitted?

will it take a few days?

[Sophia_Bush]

will take a few miles driving then will go off don't worry about it mine was on for a while then it went off by itself

[Oxas16V]

In this case you'll need an O2sim! Electronical or mechcanical!