Induction kit advice/help

[wiggyk1]

hi everyone

Just fitted a BMC induction kit as you can see and the oil breather filter

But the black cable which was connected to the old air kit is it ok to leave it like it is and not connected to anything at all???

thanks
link below of image

http://imageshack.us/a/img840/7130/wp000736.jpg

[Gandi699]

Unfiltered air is getting in with that setup currently. Either blank it off or put the breather filter on the end of the yellow tabbed press fit connector then, connect the it the middle connector to the breather on the rocker cover how it originally was.

[wiggyk1]

oh ok will it just fit right on or do i need anything

[wiggyk1]

ok just to let you i did try connect the breather to the end where the yellow connector is and it will not go on

[tomhollo18]

You need to cut the end off to get it to fit

[wiggyk1]

How much do i cut off

[tomhollo18]

I cut the whole side of that pipe of

[wiggyk1]

so basically just leave the pipe connected to the breather filter and dont use the breather filter at all

[tomhollo18]

Pm me your email address and I will send you a pic of what mine looks like