VTR Inlet on Furio

[iFurio]

Iv had a vtr inlet on my furio for a while now and followed all the steps on some of the guides on here and got it on with no problems

When you start the car it revs normally at about 1 but then literally touching The throttle pedal makes it shoot up and stay at like 3 :/ and just stays there revving like crazy. Only way to get it back to normal is by putting into gear and slowly bringing up the pedal... it starts to go down but then as soon as you put clutch down again it shoots back up :(

I'm running bigger VTR injectors as I needed them desperately at the time because my current ones went wrong and had them laying about

Iv checked for air leaks and to see of the throttle cable is pulling but all looks fine

Any help?

[Prickle]

Yeh. Put it back to what its meant to be running.

[iFurio]

I don't understand why you reply with that crap. You do what you want to your car. I'll do what I want to mine. Just wish people would help instead of being sarcastic c**ts

[Prickle]

Well read it again untill you do.

[Sophia_Bush]

change injectors back longer you run the vtrs the sooner bore was will happen

if its been working previously then started doing this then check map sensor plus stepper motor check tb cable tightness to

see if anything is sticking

[axsaxoman]

clos e the basic flap settings to get the voltage to show less than 0.6v on the tps sensor--your idle system is being over ridden due to too much voltage on tps at idle -- thats my guess anyway

[saxolover123]

im new to all this but could it be better to use a rallye? inlet on it? ive read the thread about putting one on the vtr! couldnt you do it to this one?