View Full Version : What year VTS had this loom connector
KierenCrawford
3rd December 2013, 13:20
http://http://i359.photobucket.com/albums/oo32/TJW5190/SinglePlugXregVtr_zps62522424.jpg
That is the loom connector engine to interior ...
Large Single Plug/Early Pin Layout - how hard is it to find a VTS loom to plug into my interior loom? And what years would be most likely to have what I'm after ?
Cheers Kieren
KierenCrawford
3rd December 2013, 13:21
http://i359.photobucket.com/albums/oo32/TJW5190/SinglePlugXregVtr_zps62522424.jpg
Hopefully picture works now....
PSILOS
3rd December 2013, 14:16
my 2003 saxo vts have the same...hope help you.i have the pinout if you want.
KierenCrawford
3rd December 2013, 16:06
my 2003 saxo vts have the same...hope help you.i have the pinout if you want.
Would you pm it to me
PSILOS
3rd December 2013, 16:16
1.ingition
2.reverce
3.start signal
4.oil
5.vss
6.immo
7.immo
8.obd
9.obd
10.obd
11.oil temp-quantity
12.oil temp-quantity
13.oil temp-quantity
27.oil warm
28.water temp
29.check
30.black connector 14pin dash
31. -
32. -
33. -
34.fuel +12v
35.reverce
36.alternator
KierenCrawford
3rd December 2013, 16:35
Where is No1 starting from top left ? And then 2 is the one on the right hand side of that and so on?
PSILOS
3rd December 2013, 16:41
i think we have different pinout..mine 14-26 are blank.
KierenCrawford
3rd December 2013, 16:46
I'm pretty sure the ones I don't have and you do are just temp gauges ect which my dash don't have anyway so it's not a problem
PSILOS
3rd December 2013, 17:04
http://i359.photobucket.com/albums/oo32/TJW5190/20121216_152158_zps6780ed40.jpg
this is the same with mine....
KierenCrawford
3rd December 2013, 17:25
http://i359.photobucket.com/albums/oo32/TJW5190/20121216_152158_zps6780ed40.jpg
this is the same with mine....
I see, no that's the wrong one that's the same plug type but all the pins are in a different place it's known as the " Large plug - Later pin layout " cheers anyway dude
PSILOS
3rd December 2013, 17:37
yeap..pinout..the plug is same..
KierenCrawford
3rd December 2013, 17:49
So have you got he pin out for mine so i could link the correct wires up?
PSILOS
3rd December 2013, 17:56
no sorry...but you can find it with a polymeter...i have do his job...
vBulletin® v3.8.2, Copyright ©2000-2025, Jelsoft Enterprises Ltd.